Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

s.m
New Member

How to set restriction on bandwidth/usage of a secondry link conf on FE

Greetings......

I have a client`s link configured on my FE interface as secondry.

I want to know as to how do i set restriction on its usage/througput of say 128K or 256K on that link.

Also how do i make my MRTG acknowledge that interface for monitoring purpose .Or is it that the MRTG will acknowledge it itself once i rerun the daemon (.cfg file)

1 REPLY
New Member

Re: How to set restriction on bandwidth/usage of a secondry link

You should be able to define with an access-list your client's IP addresses and use CAR to rate limit them.

I don't believe that MRTG will be able to determine this information based off of a secondary address. Unless there is some MIB that defines rate limited statistics... but I doubt it.

Mick.

85
Views
0
Helpful
1
Replies