cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
282
Views
0
Helpful
1
Replies

How to set restriction on bandwidth/usage of a secondry link conf on FE

s.m
Level 1
Level 1

Greetings......

I have a client`s link configured on my FE interface as secondry.

I want to know as to how do i set restriction on its usage/througput of say 128K or 256K on that link.

Also how do i make my MRTG acknowledge that interface for monitoring purpose .Or is it that the MRTG will acknowledge it itself once i rerun the daemon (.cfg file)

1 Reply 1

MickPhelps
Level 1
Level 1

You should be able to define with an access-list your client's IP addresses and use CAR to rate limit them.

I don't believe that MRTG will be able to determine this information based off of a secondary address. Unless there is some MIB that defines rate limited statistics... but I doubt it.

Mick.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: