Re: How to set-up privilege accesses level in Cisco 4006 cat swi

kevintang · ‎02-16-2004

I could not find this information on Cisco web site

CAT4006-S1> (enable) sh ver

WS-C4006 Software, Version NmpSW: 7.4(2)

NMP S/W compiled on Oct 8 2002, 18:12:59

GSP S/W compiled on Oct 08 2002, 15:54:51

System Bootstrap Version: 6.1(5)

Hardware Version: 2.0 Model: WS-C4006 Serial #: FOX05330QBF

Mod Port Model Serial # Versions

--- ---- ------------------ -------------------- -------------------------------

--

1 2 WS-X4013 JAB050700C5 Hw : 2.0

Gsp: 7.4(2.0)

Nmp: 7.4(2)

2 48 WS-X4448-GB-RJ45 JAB0706007V Hw : 1.1

4 34 WS-X4232-L3 JAB042500VV Hw : 1.7

5 48 WS-X4148-RJ JAE0621004W Hw : 3.1

6 48 WS-X4148-RJ JAB054100GR Hw : 3.0

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 65536K 40206K 25330K 16384K 5520K 10864K 480K 394K 86K

Uptime is 1 day, 14 hours, 17 minutes

CAT4006-S1>

milan.kulik · ‎02-17-2004

Hi,

there is no privilege accesses level scalability in CatOS.

Just user (normal,exec, non-privileged) level and enable (privileged) level.

You can go to the enable level by "enable" command (need to know the enable password) and change the config.

But no privilege accesses level tuning like in IOS.

Regards,

Milan

kevintang · ‎02-17-2004

Hi, Milan

Thanks for your web link.

Regards

Kevin

kevintang · ‎02-17-2004

Hi, Milan

Thanks for your web link.

Regards

Kevin

kevintang · ‎02-17-2004

Hi, Milan

Thanks for your web link.

Regards

Kevin

How to set-up privilege accesses level in Cisco 4006 cat switch?