Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to setup 3174 and 2611XM

Trying to setup a IBM 3174 and the Cisco 2611XM to communicate with each other.

Getting a 532 and 311 status codes on 3174.

Using 53F4779 IBM cable connecting to Cisco DCE cable connectiong to Serial 1 on 2611XM.

Please help.

Thanks

2 REPLIES
Bronze

Re: How to setup 3174 and 2611XM

debug sdlc events

and debug sdlc pack

will at lease show you if there is any traffic flowing. If you do not see anything, check that you have a clock rate on the router and that the encoding type (NRZI etc) matches the controller.

If you see traffic going to the controller but nothing coming back, chech that the polling address is correct.

Anonymous
N/A

Re: How to setup 3174 and 2611XM

Thank You we have tried this and it seems to still have the same problem. Can you send a configuration of these two pieces of equipment.

Do we have to set NRZI to 0 or 1.

On the router we set NRZI to enabled.

301
Views
0
Helpful
2
Replies
CreatePlease to create content