Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

How to setup connect E1 line between Serial Wanto E1G703 AXC 706 (Ericsson)

I am trying to install and configure a Leased-line between two sides. Topology could found here:

http://203.162.130.70/anhpt/network/topo.gif

In one side, we have one Router Cisco 2511, use port Serial WAN

At other side, we have one Router Ericsson, AXC 706, use port E1 G703.

In order to connect two sides to each others, we use modem to extend distance and convert signaling from HOST to Router Cisco.

We used encapsulation PPP protocol for this line, but entire now it couldn’t run.

Here are some lines of two Router configured:

Router Cisco:

!

interface Serial0/2

description Test for connect to Ericsson Router

ip address 10.206.0.6 255.255.255.252

encapsulation ppp

Router Ericsson:

SET DS1 INTERFACE SIGNALING MODE J0.1 NONE

SET DS1 CIRCUIT SUPERRATE J0.1.1 1:31

SET PHYSICAL PORT SPEED J0.1.1 1984000

ADD IP NETWORK ENTRY 10.206.0.6 255.255.255.252 J0.1.1

I have some questions:

1- Can we implement the system with above topology?

2- If this topology is OK. Which problem, we must to pay attention

3- I am wondering who has been implemented a system same as above topology?

103
Views
0
Helpful
0
Replies
CreatePlease to create content