Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to setup mulitple vlan access port on catalyst 4006 Sup 3

The Document indicate that the ios version 12.11b.ew1 can support mutiple vlan access port on 4006,but we can not config in fastethernet interface,anyone konw about it?

3 REPLIES
Cisco Employee

Re: How to setup mulitple vlan access port on catalyst 4006 Sup

Sup3 does not support multi-vlan ports. Can you point us to the documentation. However you can configure a port to be a trunk. Trunks carry the traffic of multiple VLANs over a single link and allow you to extend VLANs

across an entire network.

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/layer2.htm

New Member

Re: How to setup mulitple vlan access port on catalyst 4006 Sup

Thanks for you reply,the documentation point to the multiple vlan access point in Release 12.1(11b)EW was at http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_18a/ol_2170.htm#xtocid10

pls see the new software feature item for 12.1(11b)ew.The config of trunking in server must be confirm first that the server support it. BTW,if we use inter-vlan routing,how do we filter so unwanted router?

Cisco Employee

Re: How to setup mulitple vlan access port on catalyst 4006 Sup

I believe that this the multi-VLAN concept is for voice VLANs only

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/voice.htm#xtocid1

If your server NIC is capable of trunking, you can configure the switchport to trunk

86
Views
0
Helpful
3
Replies
CreatePlease login to create content