Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to setup redundancy for LAT translate?

If I have 2 routers each with their own IP paths to the same remote location where I host a LAT service (server), how can I setup the Translate function to be fault tolerant?

Would a link failure automatically switch the translate over to the other router? would the session need to be restarted?

1 REPLY
Anonymous
N/A

Re: How to setup redundancy for LAT translate?

I'm guessing that you are doing LAT

translation from TCP->LAT. Thus, any

fault tolerance is provided by TCP, by

default, and if TCP has multiple paths

to the destination address it will

balance them both. Or, if one path is

preferred but that path is no longer

available, any subsequent paths will be

used.

90
Views
0
Helpful
1
Replies