Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to show the prefix using a "community regular-exp" for selection?

Hi, someone know how to show all prefix in bgp table using some kind of command, like a mix between the "show ip bgp community xxxx:xxxx and show ip bgp reg-exp ?

In example: i wanna show all prefixes that starts the community number 1 and the next number be a numeric character between [0-9] and the next be the number 3: Somethink like a: show ip bgp community 1234:^1[0-9]3$

thanks in advance

Alex

ccie#9816

1 REPLY
Silver

Re: how to show the prefix using a "community regular-exp" for s

You'll have to run both commands to get this information. I can't think of any single command that issues it all. TAC could file a feature request for you.

84
Views
0
Helpful
1
Replies