Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to simulate a Frame Relay switch?

I want to simulate a Frame Relay switch with my Cisco2509 and several Cisco2600 routers,can I do it£¿and how?

Thanks!

2 REPLIES
New Member

Re: How to simulate a Frame Relay switch?

from global config mode type frame-relay switching and frame-relay lmi-type

ansi or cisco.

Then go to interface mode and type frame relay intf-type dce the clock rate.

then type frame-relay route source dlci 100 destination interface and dlci intf s1

200. Then type the same commands as above exept this time type frame-relay

route 200 int s0 100.

hth

Cisco Employee

Re: How to simulate a Frame Relay switch?

90
Views
0
Helpful
2
Replies