Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to test QoS?

Is there any solution to test that an implemented QoS (priority,..) works fine after configuration?

For example: my boss want to see if the QoS implemented in my border router works fine. But he don't know how to read packet sniffer like wireshark, Ethereal.

Best regards

3 REPLIES

Re: how to test QoS?

have a look at the following document which contains some QOS concepts and show commands that

might help you

https://supportforums.cisco.com/docs/DOC-8373

good luck

if helpful Rate

New Member

Re: how to test QoS?

How about QPM?

I have not ever used it.

Hall of Fame Super Blue

Re: how to test QoS?

iantra123 wrote:

Is there any solution to test that an implemented QoS (priority,..) works fine after configuration?

For example: my boss want to see if the QoS implemented in my border router works fine. But he don't know how to read packet sniffer like wireshark, Ethereal.

Best regards

In addition to Marwan's excellent link, it depends what you mean by testing.

If you want to show your boss that packets are being marked etc. then the doc has commands to show you that. But the real test of QOS is whether or not you are getting the service you expected for the different types of traffic you are marking. Is there some issue with the speed/throughput of your traffic ?

Jon

35826
Views
15
Helpful
3
Replies