Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HRSP route to WebInspector

I have 2 6513 routers running HSRP, and I have one WebInspector Box that has to look at all traffic coming in/out of location. Each router are located in different part of the complex, yet I have to make all traffic go thur that one url inspection tool. Is there an easier way to route traffic without MAC filtering?

4 REPLIES
Silver

Re: HRSP route to WebInspector

jamking21,

you are running hsrp, the traffic goes to the active gateway that connects to your WebInspector host. the standby gateway has no connection to the WebInspector host, so traffic is not filtered/inspected.

what lies behind the hsrp routers? does the standby router connect to another network/isp then the active gateway?

and what do you mean with "an easier way to route traffic without mac filtering"?

New Member

Re: HRSP route to WebInspector

But in case of failure, would we have to manually reconnect the url filter? We are also trying to do load balancing across both routers. That would mean we need WI to work on both routers at the same time. I have a diagram showing what we are trying to do. I use the term mac filtering to stop traffic from one router to another not to cause a loop.

New Member

Re: HRSP route to WebInspector

Hi

from you diagram;

Where is the traffic that must pass WebIns. originating from ?

rgds

nyr

New Member

Re: HRSP route to WebInspector

Right now it coming from the foundry devices(users). But we are relocating it either parallel with the 6513's or somewhere on the inside interface of both FWSM. Remember Not only hsrp but load balancing of traffic from the isp and out of location.

106
Views
0
Helpful
4
Replies