11-18-2002 11:30 AM - edited 03-02-2019 02:58 AM
Hi everybody
We have two catalyst 6500 and we want to configure hsrp between both but on active switch we have many secondaries ip address in only one vlan. How is configuration in this case?
11-18-2002 12:54 PM
You can use secondary hsrp groups. Remember the MSFC2 has a limitation of 16 hsrp groups. But, you can use the groups in more than one vlan.
11-19-2002 04:47 AM
I'll give you this example, it's right?
--------------------------------------MAIN CAT6500 (ACTIVE)
Interface vlan1
ip address 200.5.129.1 255.255.255.0
ip address 200.5.130.1 255.255.255.0 secondary
standby 1 ip 200.5.129.2
stanby 1 priority 150
standby 2 ip 200.5.130.2
stanby 2 priority 150
!
Interface vlan2
ip address 200.5.131.1 255.255.255.0
ip address 200.5.132.1 255.255.255.0 secondary
standby 1 ip 200.5.131.2
stanby 1 priority 150
standby 2 ip 200.5.132.2
stanby 2 priority 150
!
--------------------------------------BACKUP CAT6500 (STANDBY)
Interface vlan1
ip address 200.5.129.1 255.255.255.0
ip address 200.5.130.1 255.255.255.0 secondary
standby 1 ip 200.5.129.2
standby 2 ip 200.5.130.2
!
Interface vlan2
ip address 200.5.131.1 255.255.255.0
ip address 200.5.132.1 255.255.255.0 secondary
standby 1 ip 200.5.131.2
standby 2 ip 200.5.132.2
!
Question 2:
Could I have the same EIGRP GROUP in both CAT6509, but one of them is in the standby status? ( we are talking about 2 separates Cat6509, each of them with only one MSFC)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: