HSRP Configuration on a single 2610 Router with 2 Serial Interfaces

[mark.mathews]

I host several Web Sites on my network and am trying to setup some form of redundancy at the ISP portion of my Internet connection.

I'm trying to configure redundancy (automatic failover) on a 2610 router that has 2 serial interfaces. Both serial interfaces would connect to T1s from different ISPs which provide their own IP blocks.

Is it possible to use HSRP on a 2610 in this capacity? If not are there any better or at least different ideas that I could look into?

Will I need to have multiple IP's assigned to my web sites because of the different IP blocks?

Thanks in advance for any assistance with these questions.

[navasil]

If I understand your need correctly. HSRP is not your answer since HSRP is using with servers to provide gateway redundancy.

In this case you have to run BGP multihoming on your router however I don't think 2610 can handle large amount of BGP routing. Consult with your ISP is the best way