HSRP Configuration on a single 2610 Router with 2 Serial Interfaces
I host several Web Sites on my network and am trying to setup some form of redundancy at the ISP portion of my Internet connection.
I'm trying to configure redundancy (automatic failover) on a 2610 router that has 2 serial interfaces. Both serial interfaces would connect to T1s from different ISPs which provide their own IP blocks.
Is it possible to use HSRP on a 2610 in this capacity? If not are there any better or at least different ideas that I could look into?
Will I need to have multiple IP's assigned to my web sites because of the different IP blocks?
Thanks in advance for any assistance with these questions.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...