Hi all, im having trouble with my hsrp setup, I am trying to put in standby ip addresses on my interface so it reflects my current router addresses, the only problem is, its not letting me put in the subnet masks, i need to put in the 10.1.1.1/16 network for example and it wont let me, how do I get by this ?
can you explain, I have secondary addresses on my router interfaces, and pc's on the lan with different subnet addresses assigned all use this router as there default gateway by using the secondary addresses , what do I need to do in this case ? will it still work, or does it assume the subnet mask ?
In this situation if you have secondary address configured on your router interafce then you need to have hsrp standby address also in same subnet with secondary keyword and you do not need subnet mask for standby address because it will presume itself to be in the same subnet which is there for ip configured on physical interface.
I beliave you are using entire subnet of 10.1.1.1/16 at your network, and you required to put only on single virtual IP address 10.1.1.1 at "standby ip 10.1.1.1 " enough, not requre to put IP mask , also you can check with ? , after putting command" standby IP 10.1.1.1 ?"
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.