Using HSRP on point to point links is not a good design and does not make a lot of sense. Using dynamic routing protocols for your point to point link redundancy (and load sharing if desired) would be a much better way to go. HSRP should only be used on Multi-access segments where you have two routers connected, to provide clients redundancy in the case of router failure. The "track interface" command can be used in conjunction to track your E1 interfaces for function to assist in having HSRP fail over in the case of E1 failure to optimize outbound traffic flow.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...