In a switched network, I use two Catalyst 6513 with SupervisiorEngineII and MSFC2 as the core, 20 Catalyst3524 as the access switch, I configure 20 vlans and the inter-vlan routing is made possibly by HSRP in two MSFC2s.
Now I want a Ctatlyst 2948G-L3 jion the network, the problem is :Can I configure a Physical Interface with a ip address for connecting 2948G-L3 in each 6513,then configure the HSRP standby ip address for the two physical interfaces?
HSRP is not necessarily hardware dependant. So if the platform supports HSRP then you can have it join a HSRP group. I do not fully understand what you are trying to accomplish however HSRP is limited to working in the same group and the same network. I hope that helps.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.