Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HSRP problems with OSPF

hello all,

I have an architecture problem. Here is my network

architecture:

/---------------Router B---------------\

Router A LAN

\---------------Router C---------------/

On the LAN side, HSRP is configured (Router C is

active). OSPF is used as routing protocol on each

router.

If Router C fails, HSRP works well and packets pass

through router B after 10 seconds. But when Router C

comes up again, HSRP immediately (in 10 seconds)

redirects packets on Router C but OSPF routing table of Router C isn't effective before 1 minute so during 1 minute every packets are dropped. What can I do to avoid this problem?

Thanks for your help.

1 REPLY
New Member

Re: HSRP problems with OSPF

You can use the "standby preempt delay 60" directive to keep HSRP from immediately failing back to the primary router.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipras_r/1rfip2.htm#xtocid34

Mick.

106
Views
0
Helpful
1
Replies