I have HSRP configured on two routers, and they both track their BRI interfaces. When the BRI goes down the active router stays active instead of changing to the standby router. The stanbdy values are 5 away from each other and are told to decrease by 10 when their BRI interface goes down.
Is it possible to track a BRI interface with HSRP?
I am tracking bri0/0, however when the ISDN cable is physically disconnected the HSRP priority does not decrease. The ISDN shows layer 1 as being inactive, but BRI0/0 remains up as it still sees a signal. Any ideas??
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.