Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HSRP Tracking

I have two 6509's each with one MSFC configured for HSRP and I am tracking their egress links. HSRP is working fine; I am having a problem with tracking. MSFC 1 tracking behaves the way it should. I shut down its egress link and the priority decrements by 10 and the active MSFC goes standby. The active states on MSFC 2 will not go standby when its egress link is shut down. The priority decrements from 110 to 100, but the active state will not change to standby. I am using IOS 12.1(8a)E4. I do not think it is IOS since it is working on the other MSFC. Any ideas?????????

2 REPLIES
New Member

Re: HSRP Tracking

Are you using the preempt command? If not a secondary will not become primary if it's priority becomes highest.

Is the priority dropping below the secondary or just equalling it? Put a 20 at the end of the track statement to drop the priority by 20 and not just the default 10.

New Member

Re: HSRP Tracking

Changing the default from 10 to 20 resolved the problem.

Thanks

99
Views
0
Helpful
2
Replies
CreatePlease login to create content