Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

HSRP

two routers , but only one Leased line for Wan LINK, is it possible to configure HSRP?

6 REPLIES
Community Member

Re: HSRP

Hi,

yes u can configure...

regards

Community Member

Re: HSRP

Hi ,

but , how?

BRs

Re: HSRP

Are your 2 routers seperated by this T1 link, or do you have 2 routers at one site and only one has a T1 (WAN) connection?

HSRP is a LAN solution for providing redundant default gateway (first hops) for devices on the LAN. So if both the routers are on same LAN segment you can configure HSRP but it won't really by much since only 1 router has a WAN/T1 connection. Does the other router have another connection that it can use to send traffic over if the T1 fails? If so then HSRP would provide fail over to that router and traffic would still go.

Erick

Community Member

Re: HSRP

we have 2 routers at one site in same LAN and only one has a T1 (WAN) connection,.

what we wanted is that if T1 is OK , but one link of active router to LAN is broken, the other router can still pass traffic through T1.

BRs

Re: HSRP

If the router w/T1 LAN's interface goes down, then there is no way traffic will get out the T1 unless there is another connection between the 2 routers at this site or that router has another connection to the LAN.

Erick

.

Community Member

Re: HSRP

Hi,

Another Gentalman has explain u..just try following conf.

interface Vlan1

ip address 10.3.1.2 255.0.0.0

standby 1 priority 120 preempt

standby 1 ip 10.3.1.1

interface Vlan1

ip address 10.3.1.4 255.0.0.0

standby 1 priority 100 preempt

standby 1 ip 10.3.1.1

All Ip's are as a example . and mask it depends on u wht mask u r using

regards

ciscobuddy

169
Views
0
Helpful
6
Replies
CreatePlease to create content