Http access to a Catalyst 3524 using Tacacs+ authentication
I configured Tacacs+ as the authentication method for accessing my Catalysts 3524 with Telnet. This works well, with CiscoSecure V2.4 as the Tacacs server. My Cat3524 are running version 12.0(5.4)WC(1).
I now try to use Tacacs+ as authentication method for the http access and have some troubles... does not work.
I found the following document on the CCC, describing the configurations of both an IOS equipment and the tacacs server :
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...