Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

I am building a home lab. I have a 1841 router connected to the ISP router and is configured and works good. I have 3550 switch

I am building a home lab. I have a 1841 router connected to the ISP router and is configured and works good. I have 3550 switch inside my network. I can ping as far as the outside interface on the router, but not further then that. No idea why. I have enabled IP routing on the switch and I have redirected all unknown traffic out of the routers interface. Can anyone suggest something. I have no idea why is not working.

 

1 ACCEPTED SOLUTION

Accepted Solutions

Hi , Check your NATing ,

Hi ,

 Check your NATing , configured on your router . When you say you cant ping further , suspecting checks to be done on NAT/PAT

 

HTH

Sandy
 

5 REPLIES
Hall of Fame Super Gold

Disable "ip routing" of your

Disable "ip routing" of your switch. 

 

Instead, configure router-on-a-stick.  Your router should be doing the routing.  Enable Dot1Q trunking between router and switch interface.  

Community Member

Hi Leo Thank you for the

Hi Leo

 

Thank you for the answer.

I tried what you said. I disable the IP routing on the switch and I configure the interface fa0/1 on the router with sub-interface and I used the encapsulation dot1q. On the switch I configured the interface that I have the PC as access and the interface that goes to the router as a trunking. But still the same problem.

Still no idea why. Normally this should work without any problem...

Hi , Check your NATing ,

Hi ,

 Check your NATing , configured on your router . When you say you cant ping further , suspecting checks to be done on NAT/PAT

 

HTH

Sandy
 

Community Member

Sorry I pressed the correct

Sorry I pressed the correct answer by mistake. I wish that was the answer.

 

I can ping the internet and any ip address or domain name from the router. But not from the pc connected to the switch

Hi ,   Kindly share me your

Hi ,

   Kindly share me your router & switch config 

1) when you say you are able to ping all destination from router , not from PC and switch following things to be checked 

a) NAT/PAT

b) LAN network extend-ability over to switch .

HTH

Sandy

 

421
Views
0
Helpful
5
Replies
CreatePlease to create content