I am getting the error "bad bearercap from <unknown>" error.
I am dialing into a 1603 from a AS5300 with a primary rate connection. I have followed a config off the website that uses dialer map statements. I get "bad bearercap from <uknown>" I beleive the call is being made as an analog call rather than an ISDN. How does the dialer decide whether to use a ISDN or an analog line?
Re: I am getting the error "bad bearercap from <unknown>" error.
It first depends on your routing table. If the address of the 1603 is in the 5300 routing table pointing to an async interface, then an async call will be made (in which case the 1603 should have "isdn incoming-voice modem" configured, along with an async interface). If the 1603 address is pointing to a sync/ISDN interface on the 5300, then a sync call will be made. If the 1603 address is pointing to a dialer interface on the 5300, and that dialer interface is associated with a sync AND async interface, then it's random as to which will be used for dialout. Obviously this last case is not recommended; async and sync interfaces should have their own dialer interfaces.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...