Hello, I am new to the cisco discussion forum, and weill fairly new to the cisco world. I am currently in school for my associates degree in the IT field. My question is...I have a network setup in Packet Tracer...4 2811 routers, 2 2950 24 port switches and some pc's...I have all routes set up, statically, cause thats what the project calls for...I can ping my networks that are directly connected but when I ping other networks I lose packets. Like I said I'm kinda a noob so bare with me...I have double checked and even triple checked my routes. I have set the clockrate and bandwidth on all the serial ports too. I wasn't sure where to post this so sorry for bothering you. Any ideas...I'm not neccessaritly looking for the answer if you could just point in the right direction.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.