MAC address of ethernet interace is:
R2#sho int
Ethernet0 is up, line protocol is up
Hardware is Lance, address is 0000.0c4a.5747 (bia 0000.0c4a.5747)
When I try to configure the NET I get this message:
R2(config)#router isis
R2(config-router)#net 00.0100.0000.0c4a.5747
%CLNS: System ID (0000.000C.4A57.00) must not change when defining additional area addresses
Afterword I do a "sho run" and although I see the "router isis" entry, there is no NET address listed under it.
What am I doing wrong? Both interface are up between the two routers and I can ping each router's interface from the other. Thanks for your help.