I have a problem with my [switch] 2950. It doesn't have the file "flash:c2950-i6q4l2-mz.121-11.EA1a.bin" and appear me the dialogue "switch:"
I have attempted to copy from other switch via TFTP and I get it, but upon copying it to the switch for xmodem (copy xmodem: fflash:c2950-i6q4l2-mz.121-11.EA1a.bin) And send a similar message to this xmodem:: I/O error
Could they help me with this? that do it occur? I have changed the cable, pc, and the software in order to transfer (TERMINAL HYPER, CRT) and I could not carry out the copy. like making operate the Switch?
PD: Excuse my english, but my first lenguage is Spanish. Thank you
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...