Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I change a role and now I have an error

I deny udp any any in input, and now I have an error:

%AMP2-FE-5-LATECOLL:Ethernet0/0 transmit error.

But my ACL is on Eth0/1 why do I have that error and how can I correct it, cause I have more collisions in the interfaces.

3 REPLIES
Bronze

Re: I change a role and now I have an error

Do you mean this error only occured after you used the ACL?

Verify this using 'show interface Ethernet0/0' and

check for the number of late collisions. Enter the

command in a 5 or 10-second interval and see if it is

increasing. If so, try removing the ACL in Ethernet0/1

and look for the error.

Here are some info on Ethernet collisions:

http://www.cisco.com/en/US/partner/tech/tk389/tk214/technologies_tech_note09186a008009446d.shtml#topic4

Hope this helps.

Re: I change a role and now I have an error

http://www.cisco.com/warp/public/63/eth_collisions.html

Hopethishelps!

Idont think it has to doanything withthe accesslist

Gold

Re: I change a role and now I have an error

look for a duplexing error, half versus full

94
Views
0
Helpful
3
Replies
CreatePlease login to create content