Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I have a problem with syslogging on Cisco5500

I have a problem with syslogging on Cisco5500. Configuration lines are:

#syslog

set logging console disable

set logging server enable

set logging server 2A.B.C.D

set logging level cdp 5 default

set logging level mcast 5 default

set logging level dvlan 5 default

set logging level earl 5 default

set logging level fddi 5 default

set logging level ip 5 default

set logging level pruning 5 default

set logging level snmp 5 default

set logging level spantree 5 default

set logging level tac 5 default

set logging level tcp 5 default

set logging level telnet 5 default

set logging level tftp 5 default

set logging level vtp 5 default

set logging level vmps 5 default

set logging level kernel 5 default

set logging level filesys 5 default

set logging level drip 5 default

set logging level protfilt 5 default

set logging level security 5 default

set logging level radius 5 default

set logging level udld 5 default

set logging level gvrp 5 default

set logging level cops 5 default

set logging level qos 5 default

set logging server facility LOCAL5

set logging server severity 5

set logging buffer 200

Even if I change severity to 7 nothing happens. Only one line reached syslogd - 2002 Jul 31 17:37:44 MSK +03:00 %SYS-5-SYS_RESET:System reset from

> telnet/192.168....

OSversion - 6.3 (When there was 5.5 I have the same results).

Does anyone know what happens ?

3 REPLIES
Cisco Employee

Re: I have a problem with syslogging on Cisco5500

Are you having issues with logging to the console or a syslog server? If it's the console..I see that console logging is disabled. If you are trying to log to a server, make sure you have set up your server to receive messages. The following page on CCO should help

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_3/config/logging.htm

New Member

Re: I have a problem with syslogging on Cisco5500

The console logging works fine even if I said in config 'set logg cons disabled' - all messages fall to console routinely. Also syslog server works correctly - it's not only one Cisco I have, it's only one Cisco wich logging into console and avoid logging almost all messages to server (except only one where I reloading this Cisco). It was on old software (5.5) and it's on the new one (6.3).

New Member

Re: I have a problem with syslogging on Cisco5500

Perhaps you should set the severity to all 6. Initially we have this problem on the 6000 and after setting it to 6, can received. Hopes it help.

113
Views
0
Helpful
3
Replies