Please note from following line, "Last clearing of "show interface" counters never ". The interface counters have never been cleared. SO what you first need to do is that, clear the counters in privilege mode, by giving the command,
clear counters int e2/0.
Now monitor the show interface statistics for over a period of 24 hours. (By monitoring this I mean, dont clear the counters there after and get back with output the next day).
Here are some warnings which i got for your show interface output, from the Cisco output interpreter. You might want to consider those facts.
WARNING: The input drop rate is greater than 5%.
This can indicate an over-utilized router.
TRY THIS: Check the CPU utilization with the 'show process cpu' command.
WARNING: The collision rate is 1.3558%, which is greater than 0.1%.
TRY THIS: Look for unterminated or overly long ethernet cables, and/or
malfunctioning transceiver(s). This may require a host-by-host inspection or
the use of a protocol analyzer.
Consider reducing the number of hosts on the segment to reduce the collison
rate, or subdividing the collision domain using switches/bridges.
WARNING: You have 2 or more reported interface resets. This can happen if
packets queued for transmission were not sent within several seconds time.
Interface resets can also occur when an interface is looped back or shutdown.
TRY THIS: Monitor the level of interface resets over time. If they are
increasing, this could be a symptom of a hardware or configuration
issue. Try swapping interfaces and or ports to identify the problem.
292190 packets have been ignored by the interface because
the interface hardware ran low on internal buffers.
TRY THIS: Monitor the ignored packets over time. If they are increasing,
paste the output from the 'show buffers'
command into Output Interpreter to see if the buffers can be tuned. Also
compare with the 'no buffer' counter and input/output queue drops. Broadcast
storms can cause the 'ignored' counter to increment.
For troubleshooting more on ethernet, check following link
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.