Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

I just put in a new network module and T1 card in my 3640 router.

How do I find the new cards that I put in the router and config them. Do I have to plug the second Ethernet into the network first or can I telnet to the serial interface on the other network module to config the new one.

1 REPLY
Anonymous
N/A

Re: I just put in a new network module and T1 card in my 3640 ro

1. go through console ad tye" sh run or sh diag "

2. locate the cards and slot position

then go ahead and configure it

or telnet onto the router and do the same as 1

95
Views
0
Helpful
1
Replies
CreatePlease to create content