Re: I'm looking for a newest .tar release for Cisco Catalyst WS-
(1)Is your Dell switch manageable?
(2)Is your Cisco switch configured?
(3)Were nodes attached to cisco switch were able to ping each other?
(4)Was there any syslog server in your network who could have given the report of system failure.
(5)There is no way to diagnose a problem until and unless that is standing in front of us.There can be a broadcast storm etc.I had a similar problem with D-Link switches connected to 4503 switch, in which a subordinate had accidently connected two uplink cables with a pair of switches.
Hence please get into the console of every switch at the point of problem hence the exact problem can be identified.
(6)It is always advised to upgrade your equipment with the latesh firmware.You can search a IOS release suitable for you at
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...