Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

i was in trouble

i boot my router which haven't enough flash space but after the loading done the output like that

vector=2, sr=0xFFFF2704, pc=0x10E018E i can't stop it

1 REPLY
Bronze

Re: i was in trouble

i am not sure what the error means. you would need to provide the complete bootup sequence in order to make any sense of it.

for now i'd suggest you power cycle the router and break into rommon. For a list of standard break sequences see URL: http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

From there, load the boot recovery image ( if available ) on the router and see if you move on from there.

73
Views
0
Helpful
1
Replies