Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IBM DB2 Connect to Cisco 2950T-24 Switch has some problem

I have some problemes with IBM DB2 connect to cisco 2950T-24 switch.

When users use the client to connect the IBM DB2 server,it's okay.

But when the user idle to long ,then user want to use the server again.

It will appear a error mesenger on the user monitor.If the client plug in D-Link 10/100 M Hub,it's okay. I have fixed both the cisco switch port and server's NIC speed,duplex. But this suitation is appear again.I have no idea to do it.

Excuse me,anybody has this question?

2 REPLIES
Bronze

Re: IBM DB2 Connect to Cisco 2950T-24 Switch has some problem

Current Issues in SNA and IP Migration is mentioned in the following document:

http://www.cisco.com/en/US/products/hw/modules/ps2643/products_white_paper09186a0080091ed8.shtml

New Member

Re: IBM DB2 Connect to Cisco 2950T-24 Switch has some problem

Hi David, Try to use the port fast in the port of the switch , some application no support time delay and if the port go down when the machine have a long time idle is possible that the NIC too, Port fast skip some step of the spannind tree and the time to up is perfomance.

Franklin Lopez

103
Views
0
Helpful
2
Replies