You shouldn't directly attach the Type 1 to an active port designed for UTP/Cat(anything). It is a severe impedence mismatch and it's likely (depending on your setup) that the shield will not be properly grounded ... which may also cause adverse affects to the signalling.
The performance would be significantly degraded, even for short runs.
I don't believe the port would be at risk, but it could be a possibility .. depending on the (port) transciever's tolerance to high SWR.
You may be able to squeeze by if it's an emergency, but normal day-to-day operation shouldn't even be considered.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...