02-10-2003 12:53 AM - edited 03-02-2019 04:56 AM
I have attached a Foundry switch to my Cisco router. I have applied an IP to the Foundry layer 2 switch. I have link and protocol "UP" status on the Cisco and have link lights on my Foundry cross connect. However, I am unable to ping the Foundry from the Cisco across the link. I believe it may be a layer 2/3 problem, but need better information on where or what may be causing this problem.
Thank You.
02-10-2003 12:58 AM
If the link and protocol are both UP:
- verify correct ip address and subnet mask setting on both devices
- check duplex and speed configuration on both sides, they should match.
- check for CRC, FCS, and other errors
- try using a known good cable.
Goodluck.
02-10-2003 02:03 AM
YOu might allso want to check the vlans on the ports and the vlan of the managment interfaces of both switches.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: