Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ignore-hw local-loopback

Hi,

----------------------------------------------------

ignore-hw local-loopback

To disable the monitoring of the LL pin when in DCE mode, use the ingnore-hw local-loopback interface configuration command. To return to the default, use the no form of this command.

ignore-hw local-loopback

no ignore-hw local-loopback

-----------------------------------------------------

I didnt find this command in cisco router 2600 ver 12.0. The serial router interface works at 2Mb/s. When, there are many interruption in the patton modem,the serial interface become looped. Thsi command resolve my problem, but i didnt find it.

Thnaks for help.

2 REPLIES
VIP Purple

Re: ignore-hw local-loopback

Hello,

I think this command only works when your interface is in DCE mode (when the clock rate is set on PPP interfaces, or when the clock rate and interface type is set to DCE on Frame Relay interfaces).

Regards,

GP

New Member

Re: ignore-hw local-loopback

Hello,

Thanks. It's OK. But, did you know another command to disactivate the loop of the interface? Or it is relatively to the modem ?

Thanks

118
Views
0
Helpful
2
Replies
CreatePlease to create content