Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IGX card showing ACTIVE-f state ( UXM ) card

I am running 9.2.30 on IGX 8430.

I am having UXM card with version J with model B. As shown below.

32 UXM BEJ E1-IMA AC Active-F

I want to know why it is showing active fail .

I want to know how to rectify this problem.

I want to whether UXM version is a new version or not.

3 REPLIES
Anonymous
N/A

Re: IGX card showing ACTIVE-f state ( UXM ) card

All cards perform internal tests to monitor their integrity, when is alarmed an error condition has occur, but service is still operational. The command resetcd f eliminates this condition.

Model J is the recommended one for UXM in 9.2.30

Cisco Employee

Re: IGX card showing ACTIVE-f state ( UXM ) card

It is advisable to check the error being registered before clearing the alarm. This can be done with the dspcd command. The error will be at the bottom of the right hand column.

Also, ABJ is an older firmware release. You may want to review the newer releases for bug fixes, particularly if you are running IMA.

Cisco Employee

Re: IGX card showing ACTIVE-f state ( UXM ) card

It is advisable to check the error being registered before clearing the alarm. This can be done with the dspcd command. The error will be at the bottom of the right hand column.

You can also check for historical errors on the card. Dspcderrs and see if they are relevant to the error currently logged.

Also, ABJ is an older firmware release. You may want to review the newer releases for bug fixes, particularly if you are running IMA.

170
Views
0
Helpful
3
Replies
CreatePlease to create content