Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IMA IOS?

Hello,

I am about to implement for the first time, IMA for our internet access.

My question is, which IOS type do I need to install to get the IMA/ATM commands? They do not seem to exist on the IP/PLUS IOS.

Thanks a lot

Jeff

4 REPLIES
Silver

Re: IMA IOS?

New Member

Re: IMA IOS?

Thanks for the link.

It says my 12.3(1a) install should work. How come I do not have the ATM option when I try and configure the interfaces? See below:

System image file is "flash:c2600-i-mz.123-1a.bin"

ROUTER(config)#int ?

Async Async interface

BVI Bridge-Group Virtual Interface

CTunnel CTunnel interface

Dialer Dialer interface

FastEthernet FastEthernet IEEE 802.3

Group-Async Async Group interface

Loopback Loopback interface

MFR Multilink Frame Relay bundle interface

Multilink Multilink-group interface

Null Null interface

Serial Serial

Tunnel Tunnel interface

Vif PGM Multicast Host interface

Virtual-Template Virtual Template interface

Virtual-TokenRing Virtual TokenRing

range interface range command

I do not have the module installed yet, is that the reason?

Thanks

Jeff

Silver

Re: IMA IOS?

looking at the compatability matrix the minimum feature set you can run ima on is ip plus , the image you are currently on is ip only

New Member

Re: IMA IOS?

I'm running IMA on Cisco IOS 12.3-1 with the IP Plus feature set.

279
Views
0
Helpful
4
Replies