Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Implementation of network load balancing between two cisco 2610 rtrs

I am trying to create a load balancing system between 2 cisco 2610 routers. they are connected by two T1 lines. serial 0,1 any assistance would be appriciated.

1 REPLY
Silver

Re: Implementation of network load balancing between two cisco 2

For load balancing, you will need to have multiple paths to the remote destination, learnt via the same protocol. These routes should also be the most prefered in terms of it's administrative distance as compared to other routing protocols running on the router. You could refer to http://www.cisco.com/en/US/tech/tk365/tk80/technologies_tech_note09186a0080094820.shtml

112
Views
0
Helpful
1
Replies
CreatePlease to create content