Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Implementation of Time-based QOS/CAR, using "time-range" command

We would like to configure a Time-based QOS/CAR Policy to allow our ISP Customer to have more Burst BW during Weekends then weekdays. In our setup, we color all Burst traffic of all Customers with precedence 1 and then allocate some amount of BW to this shared Pool for precedence 1. So, using Cisco's Technology of "time-range", we have done following config to achieve the said objective. But we are not able to achieve the automatic activation of weekday CAR despite the fact that weekend acces-list/Car gets automatically get deactivated when week-end is over and weekday access-group i.e. 197 gets activated (gets activated but no match in access-group & CAR, can see using show access-list & sh interface rate-limit | include access-group 199 command)

Would appreciate yr valuable input to achieve the desired task.

Configuration :

Interface HSSI 2/0/0

rate-limit output access-group 199 6000000 32000 32000 conform-action transmit exceed-action drop

rate-limit output access-group 197 5000000 32000 32000 conform-action transmit exceed-action drop

Global Coonfig :

access-list 197 permit ip any any precedence priority time-range WEEKDAYS

access-list 199 permit ip any any precedence priority time-range WEEK-END

time-range WEEK-END

periodic weekend 00:00 to 23:59

!

time-range WEEKDAYS

periodic weekdays 00:00 to 23:59

Note : Customer's Burst Pkts have already been colored with precedence bit 1 i.e priority in CAR statement which are above of these two CAR statements(these CAR statements come in last).

106
Views
0
Helpful
0
Replies