Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

implementing dynamic vlan

I want to implement vlans so as the users m/cs are not binded to ports , i.e ports should get assigned to vlans as per the mac address.

H/w i have got is

3550xl switches and 2950g 24 switches.

is it possible with the existing h/w ?? if yes then how ??

Please advice.

sanjeev

3 REPLIES
Cisco Employee

Re: implementing dynamic vlan

New Member

Re: implementing dynamic vlan

Thanks

this information i got while searchig the vlan configs , which says u can use a 5000 switch as vmps server which will get the mac-vlan table from a tftp server.therefor with my current setup i can not configure vmps.

Please tell me why the commands in config mode

mac-address static vlan port exists and

in which scenerio it is used ?

sanjeev

Bronze

Re: implementing dynamic vlan

this command will add the static mac address to the point to some port to some particular vlan. Usually it uses for the multicast entries or also in some case where you are some problems where the mac address is aging out quickly or some weird networks problems with application , at that time static mac addresses are added which will never age out until the switch resets..

vmps server can be configured on cat6k, 5k, 4k at this point.,

88
Views
0
Helpful
3
Replies
CreatePlease login to create content