I have a central site connected to the Internet by a cisco 2605 from its serial 0/0 interface (using a modem). And a site A linked to the central site throught a 1600 router via a specialized line (LS) via a modem on the serial interface using private address. This site cannot access Internet with private address. ok.
But how can I using the ip nat command to allow this site to access the Internet?
N.B: At each end of the special line i have also private address 10.10.1.1 ...2
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.