Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

INACTIVE: putting Fa0/1 in inactive state because...

access VLAN is remote SPAN VLAN.

I have several 2950s cored to redundant 6513s. Many VLANs configured across these 2950s and VLAN database resides on the 6513s. Using MST. The port in question shows inactive (amber) and is configured with a user VLAN(not VLAN 1). What am I doing wrong? Thanks

2 REPLIES

Re: INACTIVE: putting Fa0/1 in inactive state because...

Can you paste a sh int fa 0/x switchport

New Member

Re: INACTIVE: putting Fa0/1 in inactive state because...

Here it is:

Switch2950#sh int fa0/1 switchport

Name: Fa0/1

Switchport: Enabled

Administrative Mode: static access

Operational Mode: static access

Administrative Trunking Encapsulation: dot1q

Operational Trunking Encapsulation: native

Negotiation of Trunking: Off

Access Mode VLAN: 810 (VLAN0810)

Trunking Native Mode VLAN: 1 (default)

Voice VLAN: none

Administrative private-vlan host-association: none

Administrative private-vlan mapping: none

Administrative private-vlan trunk native VLAN: none

Administrative private-vlan trunk encapsulation: dot1q

Administrative private-vlan trunk normal VLANs: none

Administrative private-vlan trunk private VLANs: none

Operational private-vlan: none

Trunking VLANs Enabled: ALL

Pruning VLANs Enabled: 2-1001

Capture Mode Disabled

Capture VLANs Allowed: ALL

Protected: false

Unknown unicast blocked: disabled

Unknown multicast blocked: disabled

Appliance trust: none

Switch2950#

Somehow VLAN 810 became a Remote SPAN VLAN. How can I remove this? Thanks

743
Views
0
Helpful
2
Replies