I am very confused about the "incoming called number." this command.
Once we experienced a unity problem which was that unity didn't respond the digits that user entered to retrieve mail when message notification is on. I used this command to fix the problem though I still quite understand why it fixed the problem.
Is this command only used to address the DTMF problem when unity initiate the call? How to explain this behavior in detail? I read some document but not 100% clear. Thanks
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...