You can modify the map icons by dragging them away in the way you want to see it and then use Save Layout feature, so that next time when you open the map, it will show up the same way you saved it the last time.
I did modify the layout (dragging) and Save it. This is working as expected because ADMIN views the modified layout each time. However, when ADMIN logs on from one specific workstation...all the icons show up again stacked on top of each other????
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...