Re: Increase bandwidth from E1 (2mb) to 16mb on 2600 (cisco only
I would suggest to do a network study about the traffic,different applications and the concurrent users who works with different applications..
This info will help you to decide on the bandwidth requirement to your org once that is approximately derived you can think off about going on for the hardware box with necessary cards required to support the connectivity.
so do throw more lite on the application and concurrent user info which will help to decide on the hardware box with cards and the bandwidth (required) which can serve the purpose here..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...