Has anyone changed the MTU for Ethernet from the default 1500 to a greater number. We currently run our backups over FDDI which we are running a MTU of 4352. When we run them over 100 Meg Ethernet the backups take 25% longer. I am wondering if I increase the Ethernet MTU if that will help. Does anyone know what I can change the MTU on Ethernet to or if I shouldn't even mess with it.
I don't think u need to change MTU for increasing the back up speed.The default 1500 bytes r normally sufficient for good performance.You can increase MTU by going to that int and changing mtu with the command MTU < of="" bytes="">.>
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...