Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Info 2610XM router

Hi everibody.

Can I put a interface card : NM-1FE-TX—One-port Fast Ethernet (10/100BaseTX interface)   on a 2610XM in order to obtain the second Fast Ethernet port??

Thanks

Massimo

Everyone's tags (3)
8 REPLIES

Info 2610XM router

Hi there,

According to the following document, this combination is not supported:

http://www.cisco.com/en/US/products/hw/routers/ps274/products_data_sheet09186a0080091b89.html

You can opt for the NM-1E or NM-4E instead.

Another great help for labs (escpecially routing labs) is GNS3: http://www.gns3.net/

regards,

Leo

New Member

Info 2610XM router

Thank you guys.

Is it correct that NM-1E or NM-4E support only 10Mbps and not 100Mbps  ??

Thanks

Massimo

Hall of Fame Super Gold

Info 2610XM router

As what Leo said, won't work.  NM-1FE isn't supported on that particular model.

Hall of Fame Super Gold

Info 2610XM router

Above I see just another example of a 100% correct answer, made to help, that not being what the OP wanted to hear, has been low rated.

I have rated it again +5 leo!

The OP should learn proper forum behavoir, thanks.

Hall of Fame Super Gold

Re: Info 2610XM router

I have rated it again +5 leo!

Thanks Paolo.

PS:  There are TWO (2) of us who are named "Leo" in this thread. 

Re:Info 2610XM router

Yes, it is but for a lab this is hardly a problem.

Main thing is that u have more than one interface.

Regards,

Leo

New Member

Re:Info 2610XM router

Hi,

Why are you telling me that is a hardly problem for a lab?

Because my intentions are to buy same NM-1E or NM-4E.

Thanks

Massimo

Hall of Fame Super Gold

Info 2610XM router

Why are you telling me that is a hardly problem for a lab?

I believe Leo means that for a lab environment, this setup is OK.  You still, however, can't use a NM-1FE.

In production, this setup won't really work.

766
Views
17
Helpful
8
Replies
CreatePlease to create content