Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Info not showing up properly in Cisco Network Assistant? Pic...

http://members.shaw.ca/ccslai/cgi-corp-cwbb.jpg

Ignore the layout as we are reconfiguring and moving the connections so that it will be cleaner.

At any rate, the switches with the "?" are either 2948G-GE-TX or 2948. How do I go about so that Cisco Network Assistant 3.0 recognizes them as switches and can see them like the other switches?

Is there something I have to turn ON on those switches? Does them having CatOS has something to do with CNA 3.0 not being able to recognize them?

1 REPLY
Red

Re: Info not showing up properly in Cisco Network Assistant? Pic

CNA only supports switches running IOS

Check out the minimum software requirements:

http://www.cisco.com/en/US/products/ps5931/prod_release_note09186a008051d2cf.html#wp699844

132
Views
0
Helpful
1
Replies
CreatePlease to create content